SpaRelax Co.,Ltd
hut tub Knowledge

Spa hut tub Jets installation and production

SpaRelax Co.,Ltd | Updated: Apr 18, 2016


We recommend that you clean your Spa jets when you drain your spa. However, if you do need to clean your jets in between this will be accomplished with a full spa.

1) Remove the hut tub jet internal by turning it counterclockwise to the off position until it stops. Continue to turn the jet past the stop point to loosen it from the hut tub spa. The jet internal will now pull out.

2) Soak the jet internal in a mixture of 1 part vinegar to two parts warm water for 2-3 hours. Periodically rotate the spinner nozzle to break up residue in the jet.

3) Rinse the jet internal with warm water.

4) Reinstall the jet internal into the Hot Tub jet body and turn clockwise until fully seated, then tug to make sure it is seated properly. You can then continue to turn clockwise until it stops.

NOTE: A jet with stainless steel cover can be slippery. You can use a soft cloth or jar-opening pad to assist in removing and installing the jet.

CMP Jets installation:

1There is Convex point on the nozzle surface cover,  see below pictures,  put A area o fwhrilpool jets cover  into the place between B-B in jets body, and then press down firmly.



Product Categories

Fast Track

© SpaRelax Co.,Ltd